Franz and Grubb Triumph degree wheel


This accurate and attractive aluminum degree wheel is hand finished, anodized, and permanently laser marked in one degree increments. It is 7 inches in diameter with a 7/16" center hole to fit the crankshaft rotor stud on most Triumph motorcycles. Each degree wheel has been turned on a lathe to insure a crisp edge, double checked for flatness, and prepared to achieve a smooth finish before anodizing.
This is a quality tool that feels good in your hand.
We have made a limited run of different colors, and when they are gone they are gone.
See below for available colors.

An accurate degree wheel is an invaluable tool for any engine builder.
It can be used to degree camshafts, set timing on magneto or points ignitions, and even degree magneto cam rings.